Bullet Resistant

   



 

SafetySteel laminates provide strength and security in institutional and safety-conscious settings by resisting penetration from a variety of small arms fire as well as impact-induced spall.

SafetySteel is compliant with National Institute of Justice, NIJ 0108.01, Underwriters Laboratories Standard.

 
   

Threat Level

Rating

Max

Thickness

38 Special

I

48x96

5/8"

9 mm

II-A

48x96

11/16"

357 Magnum

II-A

48x96

11/16"

308 Winchester

III

38x72

15/16"

44 Magnum

III-A

48x96

7/8"

AK-47

IV

38x72

1-5/16"

 
   
   

Bomb Resistant

 
Modern building requirements make much greater use of glass than older buildings, which means that most bomb casualties today are caused by flying glass.

   

SafetySteel is Arena Tested at U.S. Marine Base, Quantico VA

50 lb. of TNT @ 7.5'

1" thick SAF-GLAS

no thru openings, low hazard spall

50 lb. of TNT @ 15.0'

7/8" thick SAF-GLAS

no thru openings, no spall

Claymore Mine @ 30.0'

11/16" thick SAF-GLAS

no thru openings, low hazard spall

Claymore Mine @ 75.0'

9/16" thick SAF-GLAS

no thru openings, no spall

Hand Grenade @ 6.0'

9/16" thick SAF-GLAS

no thru openings, low hazard spall

Hand Grenade @ 6.0'

9/16" SAF-GLAS/ shield

no thru openings, no spall

   
   

Physical Attack

   

SafetySteel forced entry glass provides the ultimate in protection of life and property. Upon impact, the outer glass layers may break, but the strength and resiliency of the polycarbonate interlayer will repel attack.

SafetySteel can be fabricated to resist any physical assault or intentional impact by increasing the thickness of its proprietary construction
 

Threat Level Rating Max Thickness
WFML
Forced Entry
30Min 42x84 7/16"
WFML
Forced Entry
60Min 42x84 7/16"
   
   

Hurricane Resistant

   

SafetySteel hurricane resistant glass undergoes large missile impact and cyclic winds pressure tests. The multi-functional glazing material can readily be used in both residential to commercial installations.

SafetySteel hurricane resistant glass is certified through SBCCI SSTD 12 and
SBFC – Miami-Dade County Addition
.

 
   
   
   

Fire Resistant

   

Fire endurance test:
(1 hour to 1700°F). A standard time-temp curve for control of test was utilized. Thermo couplers and radiometers measured test heat exposure.
 
 
Hose stream test:
The impact, erosion, & cooling effects were delivered by a 2-1/2" hose through a 1-1/8" taper smooth bore tip from 20 ft.